MIDEA MPF08CR71 - Manual (Page 9)


Page 8

NOTE
The control is capable of displaying
te
m perature in degrees Fahrenheit or
degrees Celsius. To convert fro m one
to the other, press and hold the Up
and Down buttons at the sa
m e ti m e
for 3 seconds.
NOTE
When one of the above m alfunctions
occurs, turn off the unit, and check
for any obstructions. Restart the unit,
if the
m alfunction is still present, turn
off the unit and unplug the power
cord. Contact the
m anufacturer or its
service agents or a si m ilar qualified
person for service.
Auto
Timer
Swing
Control
Power
Button
LED Display
Sleep
Mode Fan
Speed
Up (+) and
Down (-) Control
Mode
Selector
(3s activate ion)
Oper
ating
Ins
tructions
Power button
Power switch on/off.
LED display
Shows the set temperature in °C or °F
and the Auto-timer settings. While on
DRY and FAN modes, it shows the room
temperature.
Shows Error codes and protection code:
E1 - Room temperature sensor error.
E2 - Evaporator temperature sensor error.
E3 - Condenser temperature sensor error
(on some models).
E4 - Display panel communication error.
E7 - Zero-crossing malfunction.
P1 - Bottom tray is full -- Connect the
drain hose and drain the collected
water away. If protection repeats, call
for service.
Mode button
Selects the appropriate operating mode.
Each time you press the button, a mode
is selected in a sequence that goes
from AUTO, COOL, DRY, FAN and HEAT
(cooling only models without). The mode
indicator light illuminates under the
different mode settings.
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing)
temperature settings in 1°C/1°F
increments in a range of 17°C/62°F to
30°C/86°F or the TIMER setting in a
range of 0 ~ 24hrs.