MIDEA Ultrasonic SCK-3Q60B - Manual (Page 4)

 Page 4 
This humidifier is pre-assembled in factory.
ASSEMBLY
RULES FOR SAFE OPERATION
SPECIFICATIONS
Model
Rated
voltage
Rated
frequency
Rated
power
Volume of
water tank
Net product
weight
Dimensions
SCK-3Q60B 120V
~ 60Hz 6L 3kg
235*325*205
mm
WARNING
• Please be sure to unplug the power cord before filling water.
• The level of the water added shall not be higher than the highest water level;
• Do not to add the water in the atomization outlet when the water is added
• Do not to lift the transparent part of the upper end of the water tank by
hands when the water is added;
• Please do not add additives like essential oil, perfume, drug, etc. to the water.
But you can add aroma liquid in the built in aroma tray.
• Please use the purified water or distilled water below 104°F(40).
NOTICE
• The following are the design parameters of SCK-3Q60B. The measured
parameters are subject to the product; The humidification amount will vary,
depending on the temperature and humidity in the room.
Actual humidification amount is not less than 90% the standard 250ml/h.
105W
• The suitable ambient temperature for use of this product: 41°F~104°F,relative
humidity:<80%RH (Please use pure water with temperature is less than 104"F)
• Do not run cord under carpeting.
• Do not cover cord with throw rugs, runners, or similar coverings.
• Do not route cord under furniture or appliances.
• Arrange cord away from traffic area and where it will not be tripped over.
• The accuracy rate for the humidity indication is approximately
± 10%RH, time is
needed when measuring the humidity. There will be minor accuracy rate
difference among the qualified sensors, and the location of placing would
impact the accuracy rate as well.