Xiaomi Redmi 12 - Manual (Page 3)

fuel or chemical transfer or storage facilities, or areas where the air may contain
chemicals or particles such as grain, dust, or metal powders. Obey all posted signs
to turn off wireless devices such as your phone or other radio equipment. Turn off
your mobile phone or wireless device when in a blasting area or in areas requiring
“two-way radios” or “electronic devices” to be turned off to prevent potential
hazards.
• Do not use your phone in hospital operating rooms, emergency rooms, or intensive
care units. Always comply with all rules and regulations of hospitals and health
centers. If you have a medical device, please consult your doctor and the device
manufacturer to determine whether your phone may interfere with the device’s
operation. To avoid potential interference with a pacemaker, always maintain a
minimum distance of 15 cm between your mobile phone and the pacemaker. This
can be done by using your phone on the ear opposite to your pacemaker and
not carrying your phone in a breast pocket. To avoid interference with medical
equipment, do not use your phone near hearing aids, cochlear implants, or other
similar devices.
• Observe all aircraft safety regulations and turn off your phone on board aircraft
when required.
• When driving a vehicle, use your phone in accordance with relevant traffic laws
and regulations.
• To avoid being struck by lightning, do not use your phone outdoors during
thunderstorms.
• Do not use your phone to make calls while it is charging.
• Do not use your phone in places with high humidity, such as bathrooms. Doing so
may result in electric shock, injury, fire, and charger damage
• Connect the “Redmi 12” to computer using a USB data cable.
• Use the USB cable included in the gift box with a Mi brand charger (maximum
output of less than 22.5W) and then connect it to a power strip.
• You can also use any third-party charger that complies with USB2.0 or higher
protocol standards and also meets the requirements of the International
Information Technology Equipment Safety Standard (IEC 60950), Audio/video,
Information and Communication Technology Equipment Standard (IEC 62368-1) and
the related laws and regulations of your country or region.
• Please note that the product allows the use of chargers with the maximum output
of 22.5W. The maximum voltage shall not exceed [10 V] and the maximum current
shall not exceed [2A].
• Using other chargers that do not meet the above requirements to charge this
product may damage the product itself and your personal or property safety.
Security Statement
Please update your phone’s operating system using the built-in software update
feature, or visit any of our authorized service outlets. Updating software through other
means may damage the device or result in data loss, security issues, and other risks.
EU Regulations
RED Declaration of Conformity
Xiaomi Communications Co., Ltd. hereby declares that this GSM / GPRS / EDGE / UMTS
/ LTE Digital Mobile Phone with Bluetooth and Wi-Fi
23053RN02Y is in compliance with the essential requirements and other relevant
provisions of the RE Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.mi.com/en/certification
RF Exposure Information (SAR)
This device is in compliance with Specific Absorption Rate (SAR) limits for general
population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit:
2.0W/kg) specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and
RED (Directive 2014/53/EU).
During SAR testing, this device was set to transmit at its highest certified power level
in all tested frequency bands and placed in positions that simulate RF exposure during
use against the head with no separation and near the body with a separation of 5 mm.
SAR compliance for body operation is based on a separation distance of 5 mm between
the unit and the human body. This device should be carried at least 5 mm away from
the body to ensure RF exposure level is compliant or lower than the reported level.
When attaching the device near the body, a belt clip or holster should be used which
does not contain metallic components and allows a separation of at least 5 mm to be
maintained between the device and the body. RF exposure compliance was not tested
or certified with any accessory containing metal worn on the body, and use of such an
accessory should be avoided.