Head replacement, Replacing the head, Specifications – Roland PD-85 - Dual-Zone 8" V-Pad for TD-Series Modules (Black) User Manual

Page 5

Advertising
background image

5

The performance of the head and/or hoop rubber will
diminish with use over time. If the head is torn or becomes too
fatigued, or impossible to tension correctly, then it should be
replaced. If the hoop rubber is worn out, it too can be
replaced.

For replacement heads or to have the hoop rubber replaced,
please contact your dealer or a Roland service center.

1.

Remove all tuning bolts and washers from the

PD-85.

Press the lock bushing (in figure below) in place with
your finger as you remove each tuning bolt, to prevent
the bushings from being pulled off the frame.

fig.Replace.e

* The lock bushings prevent rotation and loosening of the tuning

bolts caused by vibrations that are transmitted from the hoop as
you play.

2.

Remove the hoop.

3.

Remove the old head.

4.

Place the new head on the frame.

5.

Place the hoop onto the head.

6.

Pass the tuning bolts through the washers,

then attach them to the hoop and frame.

7.

Next, adjust the tension of the head. Refer to

“Adjusting the Head Tension” (p. 2).

Do not firmly tighten a single tuning bolt by itself. Doing
so will make it impossible to tension the head evenly, and
will cause malfunctions.

If a lock bushing happens to become separated from the
frame while the head is being replaced, position the
bushing so its four slots are aligned with the
corresponding ridges in the frame, then press down
firmly on the bushing.

fig.LockBush.e

PD-85 (V-Pad)

Pad size:

8 inches

Triggers:

2 (Head, Rim)

Dimensions:

245 (W) x 310 (D) x 95 (H) mm

9-11/16 (W) x 12-1/4 (D) x 3-3/4 (H) inches

Weight:

1.7 kg

3 lbs 12 oz

Accessories:

Owner’s manual, Connection cable,
Tuning key

Options (sold separately):

Pad mount (MDH-10U)

Drum stand (MDS series)

962a

* In the interest of product improvement, the specifications and/

or appearance of this unit are subject to change without prior
notice.

Head Replacement

Replacing the Head

Tuning key

Hoop

Hoop rubber

Lock bushing

Washer

Loosen

Tighten

Frame

Tuning bolt

Specifications

Lock bushing

Frame

PD-85_e.fm 5 ページ 2021年7月8日 木曜日 午後5時9分

Advertising