Samson S-MAX MCD2 Pro 2-Channel Passive PC Direct Box - Manual (Page 5)

ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Setup
The MCD2 Pro can be quite useful on stage or in the studio for connect-
ing unbalanced audio sources or instruments with pickups. By utilizing
the MCD2 Pro, the signal can be sent cleanly for long distances while
benefiting from the low noise and common mode rejection provided by
the balanced low-level output. The diagram following shows a typical
hook-up for a DJ Controller/Interface connected to a PA system.
• Set the volume controls of your audio system to the off position.
• Connect the stereo outputs of your DJ Controller/Interface or other
audio source to the Left and Right Input jacks of the MCD2 Pro.
• Connect the Left and Right BALANCED OUTPUT jacks to a pair of
microphone inputs of a mixer or other audio device.
• Pan the input channels of the mixer left and right.
• Raise the level of the audio system to the appropriate level.
• If you hear a hum or buzz set the GROUND LIFT switch to the LIFT
position.
• If you hear distortion, set the pad switch to the -12dB position. You
may need to adjust the input level of the mixer to make up for the
attenuated signal.