Samson AH8 AirLine 88 Wireless Fitness Headset Microphone Transmitter (D: 542 to 566 MHz) - Manual (Page 8)

8
Quick Start
Position the AH8 transmitter about 3–12” (8–30 cm) from the front of the CR88x with the
transmitter’s IR window facing the IR transmitter on the front panel of the CR88x receiver.
When the transmission is complete, the
CR88x will receive RF signal from the
transmitter. The READY indicator will light
on the front panel of the CR88x receiver.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
Turn on your connected amplifier or mixer, but keep
the volume all the way down. Set the Volume knob
on the CR88x fully clockwise (to its “10” setting).
This is unity gain.
Speak or sing into the microphone and slowly raise
the volume of your amplifier or mixer until the
desired level is reached.
If you find the system has noticeable dropouts,
reduced overall working range, or unexpected noise
bursts, change the operating channel of the system
using the steps above.
Note: The AH8 will only accept infrared transmission from the receiver for the
first 10 seconds after the AH8 is powered on. If you need to change the operating
channel, the AH8 must be first powered off, then powered on again to receive the
new channel.
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter