Samson Expedition XP300 6" 2-Way 300W All-in-One Portable Bluetooth-Enabled Stereo PA System - Manual (Page 9)

ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Quick Start
1. Be sure that the XP300’s POWER switch is set to the OFF position.
2. Turn each of the channel LEVEL and MASTER volume controls fully counterclockwise, to
the “0” position.
3. Next, connect one side of the included power cable to the XP300 mixer’s power inlet and
the other to a grounded AC power outlet.
4. Connect your microphones using standard XLR cables, instruments using 1/4” phone
cables, and MP3 player using 1/8” cable, into the appropriate jacks on the mixer.
5. If using a Samson XPD Wireless Microphone ssytem, plug the receiver into the CH 2 USB
jack.
6. Switch on all equipment connected to the XP300 first, then switch the XP300’s POWER
switch to the ON position.
7. Turn the MASTER level control about 1/2 of the way up.
8. Start talking or playing into channel 1 while slowly adjusting the LEVEL control until you
have reached the desired level. Do the same for each channel you are using.
9. If you notice that the LIMITER indicator is lighting constantly, turn the MASTER volume
down so that the indicator only lights occasionally during loud hits.
XP300 • Portable PA System 9