Sony BDP-S1700 Blu-ray Disc Player - Manual (Page 55)

55 GB
T
roubl
eshooting
/
S
p
ecific
a
tions
• Do not place the receiver near device
such as a TV, VCR, or tape deck. (If the
receiver is being used in combination
with a TV, VCR, or tape deck, and is
placed too close to that device, noise
may result, and picture quality may
suffer. This is especially likely when using
an indoor antenna (aerial).)
• Use caution when placing the receiver on
surfaces that have been specially treated
(with wax, oil, polish, etc.) as staining or
discoloration of the surface may result.
On operation
Before connecting other device, be sure to
turn off and unplug the receiver.
On cleaning
Clean the cabinet, panel, and controls with
a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol or benzine.
On replacement of parts
In the events that this receiver is repaired,
repaired parts may be retained for reuse or
recycling purposes.
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA models only)
With 6 ohm loads, both channels driven,
from 20 Hz – 20,000 Hz; rated 90 watts per
channel minimum RMS power at stereo
mode, with no more than 0.09% total
harmonic distortion from 250 milliwatts to
rated output.
Amplifier section
1)
Speaker impedance use
6 ohms – 16 ohms
Minimum RMS Output Power
(6 ohms, 20 Hz – 20 kHz, THD 0.09%)
90 W + 90 W
Stereo Mode Output Power
(6 ohms, 1 kHz, THD 0.9%)
105 W + 105 W
Surround Mode Output Power
2)
(6 ohms, 1 kHz, THD 0.9%)
145 W per channel
1)
Measured under the following conditions:
2)
Reference power output for front, center,
surround, and surround back speakers.
Depending on the sound field settings and the
source, there may be no sound output.
Frequency response
Analog
10 Hz – 100 kHz, +0.5/–2 dB (with
sound field and equalizer bypassed)
Input
Analog
Sensitivity: 500 mV/50 kilohms
S/N
3)
: 105 dB (A
4)
, 500 mV
5)
)
Digital (Coaxial)
Impedance: 75 ohms
S/N: 100 dB (A
4)
, 20 kHz LPF)
Digital (Optical)
S/N: 100 dB (A
4)
, 20 kHz LPF)
Area Power requirements
USA, Canada,
Taiwan
120 V AC, 60 Hz
Oceania, Europe 230 V AC, 50 Hz