Sony Multi Interface Shoe Adapter - Manual (Page 14)

14
- Pairing the unit or establishing encrypted transmission
with a different receiver.
- Pairing the receiver that was paired with the unit with
a different transmitter.
- Establishing encrypted transmission between the
receiver and a different transmitter.
Power source priority setting (POWER
PRIORITY)
This device can be configured to use a priority power
source when batteries are installed and when connected to
a USB power source at the same time.
When the priority power source has been exhausted, it
automatically switches to the other power source.
BATTERY: Operates using the batteries as the priority
power source.
EXTERNAL: Operates using USB as the primary power
source.
The transmitter may temporarily be turned off and
restarted when switching power sources depending on the
battery type and status and the USB power source.
Resetting parameters to their factory
settings
(FACTORY PRESET)
All parameter settings can be returned to their factory
settings.
Holding down the SET button until a message appears
asking for confirmation. Press the + or – button repeatedly
to select YES, and then press the SET button to enter. The
transmitter parameters are reset to their factory settings.
• The setting for this function cannot be changed during
actual signal transmission. To change the setting, turn
off the power first. Then while holding down the SET
button, turn the power on. Then change the setting after
the signal transmission has stopped.
• To start signal transmission with the factory parameter
settings, turn off the power and then turn it on again.
Displaying the software version
(VERSION)
The version of the transmitter software can be displayed.
Attaching With the Soft
Case
The transmitter can be attached to the user with the
supplied soft case.
Changing the direction of the belt
clip
The belt clip attached to the rear of the soft case can be
rotated 0, 90, 180, or 270 degrees in relation to the unit.
When changing the direction of the belt clip, rotate the clip
while pressing the switch at the top of the clip, and make
sure that the clip is locked into place at your desired
position.
Wrapping the microphone cable
around the soft case
A hook and loop fastener is located at the bottom rear of
the soft case for securing the lavalier microphone’s cable
after the unit is inserted into the case.
By wrapping the microphone cable that is connected to the
unit around this fastener, you can adjust the length of the
cable and reduce the stress that is applied to the unit when
the cable is pulled.
Note
Notes