Sony Airpeak S1 Professional Drone User Manual
Page 292
Digital Camera
ZV-1
Controlling the camera using an Android smartphone (QR Code)
You can control this product using your smartphone by connecting your smartphone to the camera using the QR Code.
Make sure that [Ctrl w/ Smartphone] is set to [On] by selecting MENU →
(Network) → [Ctrl w/ Smartphone].
Hint
Once the QR Code has been read, this product's SSID (DIRECT-xxxx) and password are registered to the smartphone. This
enables you to easily connect the smartphone to the product via Wi-Fi at a later date by selecting the SSID. (Set [Ctrl w/
Smartphone] to [On] in advance.)
Note
Radio wave interference may occur as Bluetooth communications and Wi-Fi (2.4 GHz) communications use the same frequency
band. If your Wi-Fi connection is unstable, it may be improved by turning off the Bluetooth function of the smartphone. If you do
this, the location information link function is not available.
When you record movies using a smartphone as a remote controller, the monitor of the product becomes darker.
If you cannot connect your smartphone to this product using the QR Code, use the SSID and password.
MENU →
(Network) → [Ctrl w/ Smartphone] → [
Connection].
QR Code
(A)
and the SSID
(B)
are displayed on the monitor of this product.
1
Launch Imaging Edge Mobile on your smartphone and select [Scan QR Code of the Camera].
2
Select [OK] on the smartphone screen.
When a message is displayed, select [OK] again.
3
Read the QR Code displayed on the monitor of this product with the smartphone.
Once the QR Code has been read, a message [Connect with the camera?] will be displayed on the smartphone
screen.
4
Select [OK] on the smartphone screen.
The smartphone is connected to the product.
You can now shoot images remotely while checking the composition on the smartphone screen.
5
292