Sony VCT-SGR1 Shooting Grip - Manual (Page 53)

Warning System 53
A
ppe
ndix
When an error is detected immediately after the system is powered on, or during operation, the display
and the tally indicator
(see page 10) provide a warning indication.
In addition, warning and alarm tones are output from the EARPHONES jack.
Note
Warning tones are only output if the BEEP (PHONE) > WARN (see page 44) setting in the AUDIO Setup menu is HIGH
or LOW.
a) Output only during recording.
b) Flashes during recording.
c) You can use the battery level/external power indication on the display to check the state of the battery. (
see page 14 , 22)
Warning System
Warning tones
:
1 beeps/second
:
4 beeps/second
:
Continuous tone
Alarm tones
:
1 beeps/second
:
4 beeps/second
:
Continuous tone
Tally indicator
:
1 flashes/
second
:
4 flashes/
second
Description SR-R4
operation Countermeasures
— — — An error as
indicated by
warning message
has occurred.
(Excluding “Servo
lock lost during
recording” below) Operation
continues. Check the warning
message, and resolve
the condition.
a) — b) Servo lock lost
during recording Recording
continues, but
results may
invalid. Check the input signal.
— An error occurred. Operation
continues or
stops,
depending on
the type of
error.
Check the error
message, and resolve
the condition.
Alternatively, contact a
Sony service
representative.
— a) SRMemory card is
almost full. Operation
continues. Prepare to replace
SRMemory card.
— SRMemory card is
full. Recording
stops. Replace SRMemory
Card or delete
unneeded files.
— a) Battery is almost
empty.
c)
Operation
continues. Replace battery.
— Battery is empty.
c)
Operation
stops. Replace battery.