Eureka Power Pak JO-1800 - Manual (Page 3)

• 1 •
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL.
CHARGE IMMEDIATELY AFTER PURCHASE.
IMPORTANT SAFETY INSTRUCTIONS 1.
Keep the Power Pak well ventilated in order to properly disperse heat 1.1
generated while it is in use. Make sure that there are several inches of
clearance around the top and sides and do not block the slots of the
Power Pak.
Make sure that the Power Pak is not close to any potential source of flam-
1.2
mable fumes, gases or clothing.
Keep the Power Pak dry.
1.3
DO NOT allow the Power Pak to come into contact with rain or moisture. 1.4
DO NOT operate the Power Pak if you, the Power Pak, the device being 1.5
operated, or any other surfaces that may come in contact with any power
source are wet. Water and many other liquids can conduct electricity,
which may lead to serious injury.
Do not place the Power Pak on or near heating vents, radiators or other
1.6
sources of heat.
Do not modify the AC receptacle in any way.
1.7
This device does not include an internal Ground Fault Circuit Interrupter 1.8
(GFCI).
Never charge a frozen battery; therefore, do not permit the internal battery
1.9
of the Power Pak to freeze. A fully charged battery will not freeze - refer to
storage section of the manual.
WARNING: Pursuant to California Proposition 65, this product contains
1.10
chemicals known to the State of California to cause cancer and birth de-
fects or other reproductive harm.
CONTROL PANEL 2.