Lenovo L24q-35 23.8" 1440p Monitor - Manual (Page 16)

Using the On-Screen Display(OSD) controls
To adjust the settings, the user controls can be viewed through the OSD.
2560x1440
100
75
0
DCR
Brightness
Contrast
Display Mode
Scaling Mode
Over Drive
L24q-35
Input: HDMI
To use the controls:
1. Press to open the main OSD menu.
2. Use or to move among the icons. Select an icon and press to access that
function. If there is a sub-menu, you can move between options using or , then
press to select that function. Use or to make adjustments then press to save.
3. Press to move backwards through the sub-menus and exit from the OSD.
4. Press and hold for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold for 10 seconds to unlock the OSD and allow
adjustments to the OSD.
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold for 10 seconds to
disable / enable DDC/CI function. A message "DDC/CI disable" is shown on the screen.
2-4 L24q-35 Flat Panel Monitor User’s Guide