Philips Momentum 31.5" 4K HDR 144 Hz Gaming Monitor - Manual (Page 16)

14
2. Setting up the Display
1. Toggle to the right to enter OSD
Menu Screen.
2. Toggle to the up or down to select
main menu [PBP], then toggle to the
right to confirm.
3. Toggle to the up or down to select
[PBP Mode], then toggle to the right.
4. Toggle to the up or down to select
[PBP], then toggle to the right to
confirm your selection
.
5. Now you can move backward to
set the [PBP Mode], [PBP Input], or
[Swap].
6. Toggle to the right to confirm your
selection.
4 MultiView in OSD menu
[ PBP ]: Picture by Picture
Open up a sub-window
side-by-side of another
signal source.
A
(main)
B
When the sub source is
not detected:
A
(main)
B
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by
side, adjust your devices resolutions as
pop up attention resolution, you will
able to see 2 devices source screen
project to this display side by side
without black strips.
[ PBP Input ]: There are 5 different video
inputs to choose as the sub
display source: [
1 HDMI 2.1 ],
[ 2 HDMI 2.1 ], [ 3 HDMI 2.1 ],
[ DisplayPort ], [ USB C ].
SUB SOURCE POSSIBILITY (xl)
Inputs HDMI 1 HDMI 2 HDMI 3 DisplayPort USB C
MAIN
SOURCE
(xl)
HDMI 1 ● ● ● ● ●
HDMI 2 ● ● ● ● ●
HDMI 3 ● ● ● ● ●
DisplayPort ● ● ● ● ●
USB C ● ● ● ● ●
[ Swap ]: The main picture source and
the sub picture source swapped
on the display.
Swap A and B source in [ PBP ] mode:
A
(main)
B
↔
B
(main)
A
• Off: Stop MultiView function.
Note
When you do the SWAP function, the
video and its audio source will swap at
the same time.