Godox AD100Pro & AD300Pro 3-Light Kit - Manual (Page 22)

The following table lists the Available and unAvailable custom functions of this flash.
4. Exit C.Fn menu
• Press < SET > button and the Setting No. blinks.
• Turn the SET Selection Dial to select the custom function No.
3. Change the setting
1. Press the <MENU> button to enter the C.Fn meun.
• Turn the SET Select Dial to set the desired number. Press < SET >
button will confirm the settings.
• Press < MENU > button to exit.
2. Select the custom function No.
C.Fn: Setting Custom Functions
Settings &
Descriptions
ON
OFF
OFF
S1 mode
S2 mode
OFF
Auto power off without
any operation
Can be triggered as
second curtain
Wireless is on
Wireless is off
OFF
Restrictions
NO
M mode
NO
M/Multi mode
NO
Wireless mode
Setting
Signs
ON
OFF
OFF
S1
S2
OFF
30 min
60 min
90 min
OFF,
0.01~30s
ON
OFF
OFF
01-99
Functions
Beeper
S1/S2 mode
selection
Auto power off
Delay flash
Wireless
setting
ID Setting
Custom Function
Signs
BEEP
PHOTOC
STBY
DELAY
WL
ID
Choose any figure from 01-99
Meaning
A failure occurs on the recycling system so that the flash cannot fire.
Please restart the flash unit. If the problem still exists, please send
this product to a maintenance center.
The system gets excessive heat. Please allow a rest time of 10 minutes.
The voltage on two outlets of the flash tube is too high. Please send
this product to a maintenance center.
There are some errors occurred during the upgrading process.
Please using the correct firmware upgrade method.
Prompts on
LCD Panel
E1
E2
E3
E9
2. Other Protections
• The system provides real-time protection to secure the device and your
safety. The following lists prompts for your reference:
1. Over-Temperature Protection
• To Avoid overheating and deteriorating the flash head, the inner over-
temperature protection function will be activated. When the over-
temperature protection is started, is shown on the VA display.
• When the recycle time is over 10 seconds in over-temperature protection,
please allow a rest time of at lease 10 minutes and the flash will then return
to normal.
Protection Function
Other Applications
The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the
flash will be fired synchronously with the camera shutter.
Sync Triggering
- 41 - - 42 -