Impact VC-500WLN 500Ws Monolight - Manual (Page 23)

23
The Modeling Light
The Impact VC-500WLN Monolight comes with a 250 W 60 Hz halogen modeling
lamp bulb. (The 220v 50Hz kit will come with a 220v, 250 W modeling lamp).
To remove an old bulb and install a replacement bulb,
follow these steps:
1. Ensure the monolight is powered off and unplugged.
2. Using a cotton glove or soft, dry cloth, carefully
unscrew the modeling light bulb.
3. Pick up the replacement bulb with the glove or cloth
and insert the base into the modeling light socket.
Turn it clockwise until tight.
Note: The Digital Monolight has built-in SSC (soft-start circuitry) to ensure a
long modeling lamp life. When the modeling lamp is turned on, it will light up at
a minimum brightness and slowly reach full power output. This feature prolongs
the life of the modeling lamp.
Installation and Replacement Guide