Sennheiser MOMENTUM True Wireless 3 Noise-Canceling In-Ear Headphones (Graphite) - Manual (Page 21)

Using the earbuds
MOMENTUM True Wireless 3 | 21
Switching the connection to paired
Bluetooth devices/“Connections”
To selectively switch the audio connection to paired Bluetooth
devices using the “Connections” function, you require the Smart
Control app (> 23).
▷
In the Smart Control app, tap “Connections”.
The list of Bluetooth devices paired with the earbuds appears.
▷
From the list, select the paired device to which you want to con-
nect the earbuds. Make sure that the desired device is switched
on and Bluetooth is activated.
The Bluetooth audio connection between the desired Bluetooth
device and the earbuds is established.
The app connection between the device with the Smart Control
app installed and the earbuds remains active (only Bluetooth Low
Energy for communication between app and earbuds, the device
name is highlighted in bold).
Disconnecting the earbuds from a
Bluetooth device
▷
Via the menu of your Bluetooth device, disconnect the connection
to the earbuds.
The earbuds are disconnected from the Bluetooth device. The
earbuds then search for other paired devices. If no device is
found, you hear the voice prompt “No connection”. The head-
phones switch to idle mode.
If no connection is established within 2 minutes, pairing mode
is terminated and the earbuds switch to idle mode. If neces-
sary, repeat the steps described above.
If the earbuds are not paired with any Bluetooth device (the
pairing list is empty), pairing mode is permanently active.
Using the “Connections” function, you can also selectively
delete pairing information of devices without resetting the ear-
buds to the factory default settings.
Using the “Connections” function in the Smart Control app, you
can also selectively connect the earbuds to paired devices
without terminating an existing connection or deleting the pair-
ing information of certain devices (> 21).
If you want to clear the Bluetooth pairing list of the earbuds,
use the Smart Control app or reset the earbuds to the factory
default settings (> 41).