Godox TT600 Thinklite Flash - Manual (Page 14)

- 31 -
Master mode, groups can be selected from M/A/B/C/D/E; while in
Slave mode, groups can be selected from A/B/C/D/E.
● As TT600 adopts Godox wireless X system, it is compatible with
AD360II-C 、 AD360II-N 、 TT685C 、 TT685N 、 X1T-C 、 X1T-N
wireless control, etc.
● See the picture below:
12. Wireless Control Function
● The flash unit is built in with a Wireless Control Port (6) so that
you can wirelessly adjust the power level of the flash and control
the on-or-off of your flash, focus assist beam and buzzer, as well
as trigger the flash.
● To control the flash wirelessly, you need a Godox FT
series remote control set (on-camera and on-flash).
Insert its receive end into the Wireless Control Port
(6) on the flash and insert the transmit end
into the camera hot shoe. Settings made
on the hotshoe-mounted transmit and
receive ends will be
wirelessly communicated to
the flash. Then you can
press the camera shutter-
release button to trigger
the flash. You can also hold
the transmit end at hand to
control your off-camera
flash.
13.Sync Triggering
The Sync Cord Jack (7) is a Φ3.5mm plug. Insert a trigger plug here
and the flash will be fired synchronously with the camera shutter.
14. Custom Function----Sleep Function
● This product is equipped with
Sleep Function to avoid battery
drain when the flash unit is idle.
● Press <
> button and hold for 2
seconds to enter the sleep
Function Mode. The LCD panel
displays “SL” (Sleep) and
“Sleeping Time”. Idle time before
entering Sleep Mode is 10 minutes
by default. Rotate Select Dial
Using the Flash
● For full instructions on the use of FT series remote control,
see its user manual.
Transmission distance is
about 100 meters