Philips Q-Line 32BDL3510Q 32" Full HD Digital Signage Display - Manual (Page 13)

32BDL3510Q
4
2.2. Input/Output Terminals
2 1
DVI-I HDMI 2 IN HDMI 1 IN
RS232
OUT
RS232
IN
3 4 5 6 7
IR-IN
IR-OUT
PC LINE IN
USB
Service Port
RJ45
AUDIO OUT
7
9
8
10
11
12
13
USB2.0 5V 500mA
1 AC IN
AC power input from the wall outlet.
2 MAIN POWER SWITCH
Switch the main power between On and Off.
3 HDMI1 IN / 4 HDMI2 IN
HDMI video/audio input.
5 DVI IN
DVI-I video input.
6 RS232 IN / 7 RS232 OUT
RS232 network input / output for the loop-through
function.
8 IR IN / 9 IR OUT
IR signal input / output for the loop-through function.
NOTES:
• This display’s remote control sensor will stop working
if the jack [ IR IN ] is connected.
• To remotely control your A/V device via this display,
refer to page 11 for IR Pass Through connection.
10 AUDIO OUT
Audio output to external AV device.
11 PC LINE IN
Audio input for VGA source (3.5mm stereo phone).
12 USB SERVICE PORT
Connect to USB storage for main board Firmware update.
NOTE: It’s for updating firmware only.
13 USB 2.0 PORT
Connect your USB storage device and service port.
14 RJ-45 IN
LAN control function for the use of remote control signal
from control center.