Philips BDL1005X 55" Class Full HD IPS LED Video Wall Display (2x2 Videowall Bundle) - Manual (Page 19)

55BDL1005X
9
2.3.2. ID Remote Control
You can set the remote control ID when you want to use this remote
control on one of several different displays.
Press [ ID ] button. The red LED blinks twice.
1. Press [ID SET] button for more than 1 second to enter the ID Mode.
The red LED lights up.
Press the [ID SET] button again will exit the ID Mode. The red LED
lights off.
Press the digit numbers [ 0 ] ~ [ 9 ] to select the display you want to
control.
For example: press [ 0 ] and [ 1 ] for display No.1, press [ 1 ] and [ 1 ] for
display No.11.
The numbers available are from [ 01 ] ~ [ 255 ].
2. Not pressing any button within 10 seconds will exit the ID Mode.
3. If an error pressing of buttons other than the digits occured, wait
1 second after the red LED lights off and then lights up again, then
press the correct digits again.
4. Press [ ENTER ] button to confirm. The red LED blinks twice and then
lights off.
NOTE:
• Press [NORMAL] button. The green LED blinks twice, indicating the
display is in normal operation.
• It is necessary to set up the ID number for each display before
selecting its ID number.