Atlas Sound FAP40T Strategy II Series 4" 16W Ceiling Speakers (Pair, White) - Manual (Page 2)

AtlasSound.com
2/4
1601 JACK MCKAY BLVD. ENNIS, TEXAS 75119 U.S.A.
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©2011 Atlas Sound L.P
. All rights reserved. Atlas Sound and Strategy Series are trademarks of Atlas Sound L.P
. A
TS001618 RevD 8/11
Mounting Accessories
A Tile Bridge is included in the package for suspended ceiling applica-
tions. The light weight design of the FAP40T coupled with the "Dog Leg"
mounting system allows the FAP40T to mount into most drywall ceilings
without the need for a separate mounting ring.
For new construction drywall ceiling applications, the optional FA-TR4
trim ring is available. This unit provides a marked location for drywall
installers to cut around, essentially reserving the desired location in the
ceiling until final installation of FAP40T. Mounting holes are provided to
accommodate 16" or 24" OC stud / joist mounting.
The package includes an attractive press-fit grille, which nicely matches
contemporary architecture.
The FAP40T includes a secondary support point built into the termination
cover. This "ring" may be used with an auxiliary support cable in drop tile
installations.
Architect & Engineer Specifications
The loudspeaker system shall be Atlas Sound FAP40T. System shall
include a high performance 4" loudspeaker, ported bass reflex enclosure
and press-fit grille for conventional ceiling installation.
Frequency response for the system shall be 100Hz – 12kHz (±3dB),
80Hz – 15kHz (±5dB). Sensitivity shall be 87dB average.
Loudspeaker shall be compromised of a 4" cone type driver. Cone shall
be constructed of polypropylene with a butyl rubber surround. Magnet
shall be a minimum of 13oz (368.5g) and the voice coil diameter shall be
1" (25mm).
Transformer shall be a 70.7V / 100V type with 1, 2, 4, 8, and 16 watt
primary taps (@70.7V) with a front mounted tap selector switch. This
tap selector switch shall also include a transformer bypass setting for
instances where the 8
Ω FAP40T driver is to be direct coupled with
a low impedance amplifier.
Enclosure shall be an injection molded plastic design. Internal volume
shall be 85 in
3 (1.4L).
To facilitate connection in conduit systems, enclosure shall be equipped
with an access panel covering a recessed terminal cup. This cover shall
provide a
7 ⁄
8
" (22mm inside diameter) hole for top access.
External wiring shall be accomplished via a two pole terminal strip with
screw-down terminals to provide secure wire termination.
The system shall include a tile bridge assembly to reinforce the ceil-
ing material. The tile bridge shall be designed for use on either 2' x 4'
(609mm x 1219mm) or 2' x 2' (609mm x 609mm) suspended ceiling tiles.
Overall front face diameter shall not exceed 7 3 ⁄
8
" (187mm); overall height
shall not exceed 7 1 ⁄
8
" (181mm).
Grilles shall be press-fit, manufactured from 24-gauge perforated steel
mesh and finished in white epoxy. Round grille shall be 5
1 ⁄
2
" (140mm)
diameter.
The loudspeaker shall be the Atlas Sound FAP40T.
FAP40T
(Shown Installed in Drop Tile Ceiling)
FAP40T
(Dog Ears Open on Included Tile Bridge)