RCF AM 2080 Mixer-Amplifier with 2 Microphone/Line and 2 Auxiliary Inputs - Manual (Page 20)

20
ENGLISH
REAR PANEL
9 Channel 1 balanced audio input (removable connector):
IMPORTANT: it is necessary to either link the CMD pin to ground of the respective removable connector or use
the VOX function to open the audio input 1 (even when using the XLR plug for the audio signal).
P Channel 2 balanced audio input (removable connector).
See 9 (channel 1 balanced audio input) for its connection.
IMPORTANT: it is necessary to either link the CMD pin to ground of the respective removable connector or use
the RJ 45 port priority command to open the audio input 2.
{ MIC-LINE input setting (channels 1 and 2) through 4 dip-switches:
1 + Hot audio input
2 - Cold audio input
3 GND ground
4 CMD
command: input on / priority access when connected to
ground
1
OFF – PHANTOM
(IN 2)
OFF: channel 2 input phantom
power is off. PHANTOM 2:
channel 2 input phantom power is on.
2
-20 dBu – MIC
(IN 2)
-20 dBu: channel 2 input sensitivity
set to LINE (-20 dBu). MIC 2:
channel 2 input sensitivity set to MIC.
3
OFF – PHANTOM
(IN 1)
OFF: channel 1 input phantom
power is off. PHANTOM 1:
channel 1 input phantom power is on.
4
-20 dBu – MIC
(IN 1)
-20 dBu: channel 1 input sensitivity
set to LINE (-20 dBu). MIC 1:
channel 1 input sensitivity set to MIC.
] [ i u w q }
O { P o
y
t
r
e p