Eagle Electronics FishElite - Manual (Page 123)

115
Navigate a Back Trail
1. Press
MENU | MENU |
↓ to
M Y T RAILS
| ENT .
2. Press
↓ to enter the Saved Trail list, then use ↑ ↓ to select the de-
sired Trail Name| ENT .
3. Press
↓ → to
N AVIGATE
| ENT .
4. Press
↓ → to
R
EVERSE
R
OUTE
| ENT |
← to
N
AVIGATE
| ENT . The unit shows
navigation information along the trail, in reverse.
NOTE:
If you are already located at or near the end of your trail, the arri-
val alarm will go off as soon as you hit Enter. Just press
EXIT to
clear the alarm and proceed.
5. Now, begin moving and let your unit guide you.
6. When you reach your destination, be sure to cancel your navigation.
Press
MENU | MENU |
↓ to
C ANCEL N AVIGATION
| ENT . A confirmation message
will appear. Press
←|
ENT .
Transfer Custom Maps and GPS Data Files
Custom Maps:
Custom maps work only from the MMC card or SD card. When a card
containing a Custom Map File is loaded into the unit, the unit auto-
matically loads the map into memory when the unit is turned on.
Instructions for copying Custom Map Files to an MMC are contained in
the instruction manual for your MMC card reader and MapCreate 6
software. For instructions on inserting an MMC into the unit, see Sec.
2, Installation/Accessories.
GPS Data files:
GPS Data Files contain waypoints, routes, trails and event marker
icons. Instructions for copying GPS Data Files between your computer
and an MMC are contained in the instruction manual for your MMC
card reader and MapCreate 6 software.