Waves H-EQ Hybrid Equalizer - EQ Plug-In (Native/SoundGrid/Venue, Download) - Manual (Page 19)

Waves H-EQ Equalizer User Manual
19
Output Section
Output fader controls signal output level.
o
In the H-EQ Stereo component, separate left and right channel faders are available.
o
In MS and Unlinked modes, the faders move separately to accommodate for left/M and right/S channel level differences. Faders may be
re-linked momentarily using the fader link control to enable output level adjustment for both channels simultaneously.
Phase flips the phase of the signal by 180 degrees.
o
In the H-EQ Stereo component, there are separate left and right controls to adjust the phase on each channel independently.
Trim displays the maximum peak level of the output signal and its distance from 0 dBFS. Clicking on the trim value button resets it to 0, and
applies the differential to the input level.
Full-scale Output Meters with clip indicators are located above the Output faders.
Smoothing
Older versions of H-EQ may introduce a noise when a control is moved, including when controlled under automation. The Smooth feature
resolves this issue.
Normally, Smooth should be On, whether working in a new session or opening an existing session that contains instances of the new H-EQ
version. However, when a session was created with the older version of H-EQ, Smooth will automatically set to Off. This assures that there is
no change in sound.
The Smooth control is located in the WaveSystem Toolbar at the top of the plugin interface.