Envision Peripherals EN9410e - Manual (Page 12)

4
4 4
Hardware Installation
Your monitor is equipped with an automatic power supply with a voltage range
from 100 to 240 Volts AC at a frequency of 50 to 60 Hz. Make sure that your
local power supply is within the supported range. If you are unsure, please
contact your electricity supplier.
To install your Envision EN9410e monitor:
1. Make sure that the power to the computer and the power to the monitor are
both turned off.
2. Connect the D-sub video cable from the monitor’s VGA input connector to
the VGA output connector of the computer‘s graphics card.
3. Connect the power cord from the monitor’s power jack to an AC power
socket. Please make sure, that you have easy access to the power socket
so you can disconnect the unit from the power socket should you need to.
1. Power cable
2. D-sub Video Cable