Exmark LAZER ZTM - Manual (Page 17)

- 12 -
If the levers do not align with each other, when in the neutral position,
(See Fig 2) loosen the hardware and make the appropriate adjustment by
sliding/tilting the lever(s) forward or backward until properly aligned and
tighten hardware.
FIG. 1 FIG. 2
CONTROL ARM SHAFT LEVER ALIGNMENT
b) If the ends of the levers hit against each other, while in the drive position
(levers rotated in as far as possible), make adjustments by moving the
levers outwards to the neutral lock position and carefully bend them
outward. Move them back to the drive position and check for clearance,
repeat if necessary.
3.6 POSITION DISCHARGE CHUTE.
3.6.1 Loosen two (2) 5/16” nylock nuts attaching discharge chute. Lower the discharge
chute into position. Retighten nylock nuts until chute is snug but can pivot freely.
3.7 SERVICE ENGINE.
Engine is shipped with oil, check oil level and if necessary fill to the appropriate
level with SAE 10W-30 or 10W-40, AP1 service class SF or SG for operating in
temperatures above 0
°
F (-18
°
C). See Engine Operator's Manual.
3.8 SERVICE BATTERY. Machine is shipped with a dry battery.
3.8.1 Remove battery from machine. Tilt seat up to gain access to the battery.
Disconnect battery cables - negative(black) cable first. Remove battery
hold-down and lift battery out.
3.8.2 Place battery on a level surface and remove vent caps.
DANGER
POTENTIAL HAZARD
♦
Battery electrolyte contains sulfuric acid, which is
poisonous and can cause severe burns
WHAT CAN HAPPEN
♦
Swallowing electrolyte can be fatal or if it touches skin
can cause severe burns.
HOW TO AVOID THE HAZARD
♦
Wear safety glasses to shield eyes, and rubber gloves
to protect skin and clothing when handling electrolyte.
♦
Do not swallow electrolyte.
♦
Fill the battery where clean water is available for
flushing skin.
MOUNT PLATE TO
THE REAR & OUTSIDE
OF ARM SHAFT
MOTION
CONTROL
LEVER
LEVERS IN
ALIGNMENT