Echo PPT-260 User Manual
Page 26
26
To Adjust Saw Chain Tension.
1.
Loosen two guide bar nuts (A), if necessary.
2.
Turn saw chain adjuster slot (B) clockwise to tighten saw chain on
guide bar. Turning slot counter clockwise will loosen saw chain on
guide bar.
3.
Tighten guide bar nuts (A) firmly. Pull the saw chain around the
guide bar by hand. Saw chain should move freely on guide bar. If
saw chain is difficult to rotate or binds on guide bar, it is too tight.
4.
Keep the saw chain lubricated and properly adjusted and the
guide bar nuts tightened firmly at all times.
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
Standard Bar and Chain Combinations
Bar P/N
Chain P/N
chain type
links
pitch
gauge
PPF-210
PPT-230
99944200530
10" Intenz™ bar
1102373901
1917039
91
39
3/8"
0.050
PPT-260
12" Intenz™ bar
1122374401
1917044
91
44
3/8"
0.050
Optional Bar and Chain Combinations
Bar P/N
Chain P/N
chain type
links
pitch
gauge
PPF-210
99944200530
8" regular bar
1080373301
1917033
91
33
3/8"
0.050
10" regular bar
1101373901
1917039
91
39
3/8"
0.050
10" narrow bar
1100373901
1907039
90
39
3/8"
0.043
PPT-230
PPT-260
10" regular bar
1101373901
1917039
91
39
3/8"
0.050
10" narrow bar
1100373901
1907039
91
39
3/8"
0.050
12" regular bar
1121374401
1917044
91
44
3/8"
0.050
12" narrow bar
1120374401
1907044
90
44
3/8"
0.043
When converting from Intenz™ guide bar to regular or narrow kerf guide bar, see your Echo dealer for
additional parts needed.
A
B