Configuration (standalone), Sound-active mode, Automatic mode – CHAUVET DJ Swarm 4 FX 3-In-1 LED User Manual
Page 24: Display timeout, Test mode, Factory reset
Page 24 of 80
Swarm 4 FX User Manual Rev. 2
Configuration
(Standalone)
Set the product in one of the Standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any Standalone mode (Static, Automatic, or
Sound) to a DMX string connected to a DMX controller. Products in Standalone mode may
transmit DMX signals that could interfere with the DMX signals from the controller.
Sound-Active
Mode
To enable the Sound-Active mode, do the following:
Press
<MENU>
repeatedly until
Sou-
shows on the display.
Press
<ENTER>
and
Sou0
–
Sou9
will show on the display.
Use
<UP>
or
<DOWN>
to select the desired Sound-Active program.
Press
<ENTER>
.
Turn the music on and adjust the sound sensitivity knob until the product starts responding to
the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
The product will blackout when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.
Automatic Mode
To enable the Automatic mode, follow the instructions below:
Press
<MENU>
repeatedly until
Aut-
shows on the display.
Press
<ENTER>
and
Aut0–Aut9
will show on the display.
Use
<UP>
or
<DOWN>
to select the desired Auto program.
Press
<ENTER>
and
S.01–S.99
will show on the display.
Use
<UP>
or
<DOWN>
to adjust the program speed.
Press
<ENTER>
.
Display Timeout
To enable or disable the Display Timeout, do the following:
Press
<MENU>
repeatedly until
SYS
shows on the display.
Press
<ENTER>
and
LEdS
,
tESt
, or
rESt
will show on the display.
Use
<UP>
or
<DOWN>
to select
LEdS
.
Press
<ENTER>
and
on
or
oFF
will show on the display.
Use
<UP>
or
<DOWN>
to select the Display Timeout to be
on
or
oFF
.
Press
<ENTER>
.
Test Mode
To run the Swarm 4 FX in Test mode, follow the instructions below:
Press
<MENU>
repeatedly until
SYS
shows on the display.
Press
<ENTER>
and
LEdS
,
tESt
, or
rESt
will show on the display.
Use
<UP>
or
<DOWN>
to select
tESt
.
Press
<ENTER>
.
Factory Reset
To reset the Swarm 4 FX to factory defaults, do the following:
Press
<MENU>
repeatedly until
SYS
shows on the display.
Press
<ENTER>
and
LEdS
,
tESt
, or
rESt
will show on the display.
Use
<UP>
or
<DOWN>
to select
rESt
.
Press
<ENTER>
.