Strobe, Program time, Configuration (dmx) – CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects User Manual
Page 22: Starting address, Operation
Page 16
Operation
GigBAR MOVE + ILS User Manual Rev. 3
Strobe
To set the strobe on the GigBAR MOVE + ILS, follow the instructions below:
1. Press
<MENU>
to view the main menu on the display.
2. Use
<UP>
or
<DOWN>
until
AUTO
or
SOUND
is selected.
3. Press
<ENTER>
.
4. Use
<UP>
or
<DOWN>
to select
Strobe
.
5. Press
<ENTER>
.
6. Use
<UP>
or
<DOWN>
to set the strobe from
0–20
.
7. Press
<ENTER>
.
Program Time
To set the program time on the GigBAR MOVE + ILS, do the following:
1. Press
<MENU>
to view the main menu on the display.
2. Use
<UP>
or
<DOWN>
until
AUTO
or
SOUND
is selected.
3. Press
<ENTER>
.
4. Use
<UP>
or
<DOWN>
to select
Program Time
.
5. Press
<ENTER>
.
6. Use
<UP>
or
<DOWN>
to set the timer from
0–255
(seconds).
7. Press
<ENTER>
.
Configuration (DMX)
The GigBAR MOVE + ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website:
.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some of the product’s channels could be restricted.
The GigBAR MOVE + ILS uses 3 DMX channels, which defines the highest configurable address to
463
.
For information about the DMX protocol, download the DMX Primer from
To select the starting address, do the following:
1. Press
<MENU>
to view the main menu on the display.
2. Use
<UP>
or
<DOWN>
until
DMX
is highlighted.
3. Press
<ENTER>
.
4. Press
<ENTER>
again.
5. Use
<UP>
or
<DOWN>
to select the DMX Channel:
3CH
,
28CH
, or
50CH
.
6. Press
<ENTER>
7. Use
<UP>
or
<DOWN>
to select
Address
.
8. Press
<ENTER>
9. Use
<UP>
or
<DOWN>
to increase or decrease the starting address.
10. Press
<ENTER>
.