Elite Screens A56-E25B2 - Manual (Page 3)

Rev.030111‐AS
www.elitescreens.com [email protected] 3
This installation is designed to bring the
projector closer to the ceiling to accommodate
room size. The extension does not necessarily
have to be removed for the projector to be
mounted. The design of this particular mount
has the ability to be extended or flushed closer
to the ceiling. The extra accessories can be
removed and replaced with additional parts. The
extra hardware is designed to fit 90% of the
different projector types in the US. Some screws
may be required for the projector. For proper
installation, please make sure the projector has
the option of being ceiling mounted. Please
reference in the projector’s manual for mount
options. The projector mount has the capability
to tilt at a 20‐30% angle in a circular motion.
Flush Ceiling Mount
M5 x 12 Hex screws
M5 x 12 Hex screws
M5 x 12 Hex screws
M5 x 12 Hex screws
M5 Washer
d
f
e
Short extension
Extension for
spider leg.
Long extension
for spider leg.
These extensions are extra parts for mounting
purposes. By simply removing either extension
from the mount you can have it shortened or
extended depending on the size and model of
your projector. The spider legs are
manufactured to extend if needed to provide
extra extension to reach the correct mount
screw. By adding extension (e) you can have the
spider legs extended further for reaching the
projector’s screw points. Extension (d) can be
placed with extension (e) by securing it with
screw type (b). Extension (f) is an extra
accessory; the mount has 2 extensions similar to
extension (f). This will only be required if the
extensions are not long enough for your
projector.
#1