Electrolux EHG60412 User Manual

Page 3

Advertising
background image

• Use only the accessories supplied with

appliance.

• Be careful when you connect the appli-

ance to the near sockets. Do not let elec-
tricity bonds touch the appliance or hot
cookware. Do not let electricity bonds
tangle.

Installation
• You must read these instructions.

The manufacturer is not responsible
for any injury to persons and pets or
damage to property caused by failure
to obey these requirements.

• To prevent the risks of structural

damage or physical injury, installa-
tion, connection of the appliance to
the power supply and gas system,
setting up and maintenance must on-
ly be done by qualified personnel in
compliance with standards and local
regulation force.

• Make sure that the appliance is not dam-

aged because of transport. Do not con-
nect a damaged appliance. If it is neces-
sary, speak to the supplier.

• Only use built-in appliances after you as-

semble the appliance into correct built-in
units and work surfaces that obey the
standards.

• Do not install the hob over a domestic

appliances if the installation instructions
do not allow it.

• Install the appliance only on a worktop

with flat surface.

• Do not change the specifications or mod-

ify this product. There is the risk of injury
and damage to the appliance.

• Fully obey the laws, ordinances, direc-

tives and standards in force in the coun-
try where you use the appliance (safety
regulations, recycling regulations, electri-
cal safety rules etc.)

• Keep the minimum distances to other ap-

pliances and units.

• Install anti-shock protection, for example

install the drawers only with a protective
panel directly below the appliance.

• Prevent damage of the cut surfaces of

the worktop against moisture with a cor-
rect sealant.

• Seal the appliance to the worktop with no

space left with a correct sealant.

• Prevent damage to the bottom of the ap-

pliance from steam and moisture, e.g.
from a dishwasher or oven.

• Do not install the appliance adjacent to

doors and below windows. Hot cook-
ware can be hit off the hob when you
open the doors or windows.

• Before installation, make sure that the lo-

cal supply conditions (gas type and pres-
sure) agree with the adjustment of appli-
ance. The adjustment conditions for the
appliance are on the rating plate, which
you can find near the gas supply pipe.

• This appliance is not connected to a

combustion products evacuation device.
It must be installed and connected in ac-
cordance with current installation regula-
tions. Particular attention must be given
to the relevant requirements regarding
ventilation.

• The use of a gas cooking appliance

cause heat and moisture in the room
in which it is installed. Make sure
that the ventilation in the kitchen is
good: keep natural ventilation holes
open or install a mechanical ventila-
tion device (mechanical extractor
hood).

• More ventilation (for example open-

ing of a window or increasing the lev-
el of mechanical ventilation where
present) is necessary when you oper-
ate the appliance with intensity for a
long time.

• Carefully obey the instructions for electri-

cal connections. There is the risk of injury
from electrical current.

• Disconnect the appliance from the

electrical supply, before you do the
maintenance work or you clean it.

• The electrical mains terminal is live.
• Make electrical mains terminal free of

voltage.

• Install correctly to give anti-shock protec-

tion.

• A loose and incorrect mains plug and

socket connections can make the termi-
nal become too hot.

• A qualified electrician must install the

clamping connections correctly.

• Use a strain relief clamp on cable.
• Use the correct mains connection cable

and replace the damaged mains cable

electrolux 3

Advertising