EverFocus EDR920 - Manual (Page 33)

(4) RETRIGGER: Re-trigger the alarm.
YES : The duration time starts when an alarm is triggered. The duration time restarts from 0 when
a new alarm is triggered during an alarm action.
NO : The alarm signal will not be triggered again during duration time.
(5) DURATION:
Buzzer noise and event record duration of an alarm, from 1 sec to 99 seconds. The default value is
5 seconds.
(6) ALARM OUTPUT:
The setting of alarms which are NONE, 1, 2, 3 and 4.
(7) ALARM EMAIL:
Select “YES” for sending an email when alarm occurs. The email address can be set in the
NETWORK SETUP MENU.
(8) BUZZER: Alarm buzzer.
ENABLE: To enable an alarm buzzer.
DISABLE: To disable an alarm buzzer.
(9) ALARM NETWORK:
YES: Enable alarm network.
NO: Disable alarm network.
(10) MAIN MON: Display on a main monitor when an alarm occurs.
NO CHANGE: Nothing changes on the display in the main monitor when an alarm occurs.
FULLSCREEN: A full screen will pop up when an alarm occurs.
(11) CALL MON: Display on a call monitor when an alarm occurs.
NO CHANGE: Nothing changes on the display in the call monitor when an alarm occurs.
CAMERA 1~16 : Display the active camera in full screen mode to the call monitor.
32