Electrolux 1583-8 TK - Manual (Page 25)

What to do if ...
25
Symptom Possible Cause Remedy
Water on the floor or on
storage shelves. Water drain hole is
blocked. See the “Cleaning and
Care” section.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or disconnect from the
mains supply.
Light bulb data: 220-240 V, max. 15 W
☞
1. To switch off, press the ON/OFF button until the mains power light
extinguishes.
2. Unplug the mains plug.
3. To change the light bulb, undo the
screw.
4. Press the light bulb cover as shown and
slide it backwards.
5. Change the defective light bulb.
6. Refit the light bulb cover and the screw.
7. Put the refrigerator back into operation.
During operation at low ambient temperature, the light bulb works at
a lower intensity. That allows an optimal distribution of the tempera-
ture between the fridge and the freezer compartment.
Attention! The light bulb is an essential component for efficient per-
formance of the appliance!
In case of faulty bulb, you must ensure that it is replaced.
When the door is open, the light bulb operates at usual intensity.