7 configuring for single-service decryption, 8 configuring for multi-service decryption, Configuring for single-service decryption – Ericsson Distribution Receivers RX8315 User Manual
Page 15: Configuring for multi-service decryption
Quick Start Guide: Connect-Power-Configure
• Alternative audio components may be selected from the service tab on the Web
Control interface
3.7
Configuring for Single-service Decryption
When configuring for Single-service Decryption the following points should be
observed:
• If the service selected for video decode contains encrypted components these
components will automatically be decrypted by the unit.
• The outgoing feed from the unit will contain these decrypted components
providing the TS feed on the Output tab on the Web Control interface is set to
descrambled.
3.8
Configuring for Multi-service Decryption
When configuring for Multi-service Decryption the following points should be
observed:
• With Director Multi-service Decryption, when a feed containing more than one
encrypted service is applied to the unit, the first 24 services detected are
automatically decrypted. A list of these services can be found in the service
table on Services Menu.
• With Common Interface Multi-service Decryption, when a feed with more than
one encrypted service is applied to the unit, the user may choose how it is
decrypted using the Maximum CAM Services, Maximum CAM Components
and Maximum CAM Components Per Service dialog boxes. The user should
refer to the CAM vendor for CAM compatibilities before setting this up.
• This list may be modified from the CA tab on the Web Control interface.
Note: This is only applicable for units/models that have Multi-service Decryption
licenses enabled.
EN/LZT 790 0008/1 R1A
2011-03-30
15 (40)