Enviro Kodiak 1200 Fireplace Freestanding - Manual (Page 47)

47
Installation
I
NSTALLATION
O
F
T
HE
S
URROUND
P
ANEL
- I
NSERT
:
Figure 62: Screw to hold
the trim against the sur-
round.
Figure 60: Corner brackets for trim.
Figure 61: Two pieces of corner
bracket.
Installation of Trim:
The trim set for your surround panel must be installed before
installing the surround panel onto the unit, if not already done.
1. Attach one side trim to the top
trim, using a corner bracket
(see Figure 60) to secure pieces
together. There are two (2) main
pieces to each corner bracket (see
Figure 61). When installing the
corner pieces into the trim, the “B
FACE” sides must face each other
and the screw heads are to face
out. With the bracket in place and
Figure 63: Installation of Panel.
the top and a side trim snug together, use
a flat head screwdriver to turn the two (2)
screws in the bracket to tighten it into the
trim.
3. Slide the two (2) attached trim pieces onto the surround panel.
4. Attach the other side trim piece to the top trim, using the same method used
in Step 1.
5. Place the second side of the trim on the surround panel in the same manner
used on the first side and secure in the same manner.
6. On the side trims, there are holes 2” (50 mm) from either end. Use a Phillips
screwdriver to place a #8 screw 11⁄4” long in each hole and tighten (refer
to Figure 62). This will keep the
trim tight against the surround.
Installation of Surround Panel onto Unit:
There are two (2) hooks on either side of the inside of the
panel. Line up the openings on the hooks with the screws
on the outside of either shroud (see Figure 63). Push the
surround in and push it down into place.