ELAN Home Systems V883 - Manual (Page 13)

E L A N H O M E S Y S T E M S
© ELAN Home Systems 2006 • All rights reserved. Page 11
V883 INSTALLATION MANUAL
DIP Switch Settings - BAUD RATE
Set the BAUD RATE DIP switch to the 9600 position (Up) when utilizing RS-232 con-
trollers that require this baud rate. Use the 19.2k (Down) position for ELAN RS-232
applications and third party controllers that operate at 19.2k.
19.2K BAUD
(Factory Default)
1 2 3
UNIT 3
UNIT 2
UNIT 1
UNIT 4
UNIT ID
19.2K / 9.6K BAUD RATE
1 2 3
UNIT 3
UNIT 2
UNIT 1
UNIT 4
UNIT ID
19.2K / 9.6K BAUD RATE
9.6K BAUD
75 Ohm Termination DIP Switch Settings
There are eight 75 Ohm Termination DIP Switches used to optimize video signals
when sharing sources with other devices or using multiple V883s. For each input
that is shared using a ‘Y’ cable, place the corresponding DIP switch in the OFF/
DOWN position. When not sharing a source, the DIP switch should remain in the
factory default ON/UP position.
Shared
Source Not Shared
Source
ON/UP
(Factory Default)
OFF/DOWN
75 OHM
INPUT
TERM