Enterasys Networks FN 100 - Manual (Page 12)

Introduction
1-4 Software Conventions
MAC Address
Displays the manufacturer-set MAC address associated with the IP Address used
to define the device icon when it was added to NetSight Element Manager. This
address is factory-set and cannot be altered.
Informational fields describing the boards and/or ports being modeled are also
displayed in most windows:
Port Number
Displays the number of the monitored port.
Uptime
Displays the amount of time, in a X days hh:mm:ss format, that the FN100 has
been running since the last start-up.
Using the Mouse
This document assumes you are using a Windows-compatible mouse with two
buttons; if you are using a three button mouse, you should ignore the operation of
the middle button when following procedures in this document. Procedures
within the NetSight Element Manager document set refer to these buttons as
follows:
Figure 1-2. Mouse Buttons
For many mouse operations, this document assumes that the left (primary) mouse
button is to be used, and references to activating a menu or button will not
include instructions about which mouse button to use.
However, in instances in which right (secondary) mouse button functionality is
available, instructions will explicitly refer to right mouse button usage. Also, in
situations where you may be switching between mouse buttons in the same area
or window, instructions may also explicitly refer to both left and right mouse
buttons.
Left Mouse Button
Right Mouse Button