Barco ImagePRO-4K Processor User Manual
Imagepro –4k video processor, Quick start guide - setup
Note:
The ImagePRO
–4K automatically acquires and configures inputs.
Setting up an LED display
Note:
To enter the Setup menu press the Adjust Knob.
ImagePRO
–4K Video Processor: Rear-Panel Setup
Genlock
BNC Input
Quick install and setup
ImagePRO
–4K Video Processor
Quick Start Guide - Setup
P/N 26-1602004-00, Rev 01
Connect inputs
— Connect all input sources to the
ImagePRO
–4K.
1
Connect power
— Ensure that power is properly connected
to the ImagePRO–4K.
2
Getting started
Barco Technical Support:
USA:
EMEA:
China:
APAC:
Support
3
4
5
Connect outputs
— Connect the output(s) on the
ImagePRO
–4K to your projector(s) or other target devices.
Turn on power
— Turn on power to the ImagePRO–4K,
your projector(s), and to all peripheral equipment.
Factory reset
— If you are using the ImagePRO–4K for the
first time, or if you are using an ImagePRO
–4K that has just
returned from an event, perform a full factory reset to restore
default system configurations.
Press the Adjust Knob to enter the Setup menu, then select
Reset / Factory
on the display screen.
Reset / Soft Reset
keeps the user settings.
Adjust output format
— Go to
Setup / Output / AUX
Adjustment
and update the output format.
6
Native Rate
— O
n the front panel, press the Adjust Knob to
enter the Setup menu, then select
Setup / System menu
and
select the desired Native Rate.
8
Setting up outputs
9
10
Test output
— Turn on a test pattern, verify that you have an
image, and make any necessary adjustments. When
complete, turn off the test pattern.
11
Set and adjust inputs / source
— Select inputs / sources and make any
necessary adjustments to color balance, timings, and so on.
Setting up inputs / source
12
Save input / source configurations
— After adjusting an input / source,
save the input /source configuration.
Repeat steps 11 and 12 for each input / source.
13
Adjust and save system settings
— Adjust system parameters such as
Ethernet settings and HDCP parameters.
For complete details on all installation and operations procedures, please
refer to the
ImagePRO–4K User’s Guide
(R5906167).
ImagePRO
–4K User’s Guide
AC
Connect to AC
power source
Ethernet
Connect to Event
Master Toolset or
External Controller
Genlock
Generated
Reference Output
DP 1.2
Input
HDMI 2.0
Input
12G SDI
Input
12G SDI
Input
12G SDI
Input
12G SDI
Input
DP 1.2
Output
HDMI 2.0
Output
12G SDI
Output
12G SDI
Output
12G SDI
Output
12G SDI
Output
Position and adjust the image
— Use the LED Setup Menu to
position the image on the LED wall or other display device,
scale the image, adjust
Pan
and
Zoom
settings, and save your
view.
Save All
— Select
Save All
.
Save All
is the last menu item on the Setup
page.
Save All
writes system settings to non-volatile memory.
14
System settings
Assign primary output
— If the primary output is DP,
proceed to the next step.
If your primary output is HDMI/SDI, go to
Setup / Output /
AUX Adjustment
and update the primary output.
7