Holosun HE508T X2 Open Reflex Sight (Red Circle-Dot Reticle) - Manual (Page 5)

·4· ·15·
Features
Features
1) Automatic reticle intensity adjustment in Auto Mode .
2
)
32MOA circle and dot
,
2MOA dot only and 32MOA circle only
.
3) Shake AwakeTM - Motion on with last setting recall .
4) Parallax free , unlimited eye relief .
5
)
Drain holes on both sides of the optic allow for excess water to
escape during wet conditions
.
6
)
Solid Titanium Body.
7) 12 Brightness Settings: 10DL & 2NV.
8) Window Size 0 . 63x0 . 91 inches .
9) Waterproof:IP67.
Zero setting
1) This sight has been factory adjusted to an approximate 25 yard zero
and should require minimal adjustment to achieve zero.
2) The Elevation adjustment is located on top of the tail section of the
housing and the Windage adjustment is located on the right side of
the housing. Adjustment can be performed by inserting the flat-
tipped end of the included tool into the turret slot and rotating, See
Fig 7.
3) Windage and Elevation adjustments are approximately 1 MOA per
click.
4) Each adjustment click has a value of approximately 1 MOA or 1 inch
at 100 yards (1/2" at 50y; 1/4" at 25y). When zeroing at 25 yard, if your
impacts are 2 inches low and 1 inch right, you will need to adjust