Connections, controls and indicators – LD Systems CURV 500 AVS Portable Array System AV Set with Speaker Cables (Black) User Manual
Page 9
9
DEUTSCH
ENGLISH
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
•••
26
MONO / STEREO
To have a Mono summed output signal on the mixer, the MONO / STEREO (26) switch on the mixer control panel must be pressed down in
the MONO position. If the MONO / STEREO switch is not pressed down, the output signal is in stereo.
27
MAIN LED
If an audio signal is present on the sum channel, the LED lights up green. As soon as the LD CURV 500
®
array system is operated in the
clipping range, the LED turns red. Brief flashing is not a cause for concern, since the internal audio limiter compensates for over-modulation.
Permanent illumination should be avoided by reducing the input level.
28
MAIN LEVEL
Volume control for the summing channel. When turned to the left, overall volume levels are lowered, when turned to the right, they are raised.
29
SUB LEVEL
Adjusting the volume ratio of the subwoofer to the satellite speakers.
30
DSP PRESETS
Since it is possible to vary the number of connected LD CURV 500
®
satellites (1 - 4 units), the DSP settings must be adjusted accordingly,
to achieve a homogeneous sound distribution for all four variations (equalizer settings and adjusting the bass level). Set the rotary encoder
on number 1 if you only want to operate one satellite in the LD CURV 500
®
system (1 unit for mono or 1 unit each left and right for stereo).
Proceed in the same way, if you want to operate 2, 3, or 4 satellites in the system.
31
DFX PRESETS
16 different effects presets are available to you. Use the rotary encoder to select one of the presets as desired.
CONNECTIONS, CONTROLS AND INDICATORS
32
33
34
35
36
37
38
LDCURV500SE
The Subwoofer expansion LD CURV 500
®
SE, when used individually, complements the bass output of the LD CURV 500
®
array system.
Furthermore, the subwoofer expansion allows the connection of additional LD CURV 500
®
satellites. The intelligent signal control is carried
out by the DSP (digital signal processor) integrated into the LD CURV 500
®
S Subwoofer via the 5-pin XLR system cable, additional system
settings are thus not required.