Electrolux IQ-Touch 137018300 A - Manual (Page 5)

5
Safety
PREVENT INJURY
To prevent shock hazard and assure stability •
during operation, the dryer must be installed
and electrically grounded by a qualified service
person in accordance with local codes. Installa-
tion instructions are packed in the dryer for the
installer’s reference. Refer to INSTALLATION
INSTRUCTIONS for detailed grounding proce-
dures. If the dryer is moved to a new location,
have it checked and reinstalled by a qualified
service person.
To prevent personal injury or damage to the
•
dryer, the electrical power cord of a gas dryer
must be plugged into a properly grounded and
polarized 3-prong outlet. The third grounding
prong must never be removed. Never ground
the dryer to a gas pipe. Do not use an extension
cord or an adaptor plug.
ALWAYS disconnect the dryer from the electrical
•
supply before attempting any service or clean-
ing. Failure to do so can result in electrical shock
or injury.
Do not use any type spray cleanser when clean-
•
ing dryer interior. Hazardous fumes or electrical
shock could occur.
To prevent injury, do not reach into the dryer
•
if the drum is moving. Wait until the dryer has
stopped completely before reaching into the
drum.
PREVENT INJURY AND DAMAGE TO THE
DRYER
All repairs and servicing must be performed by •
an authorized servicer unless specifically rec-
ommended in this Use & Care Guide. Use only
authorized factory parts.
Do not tamper with controls.
•
Do not install or store the dryer where it will be •
exposed to the weather.
A thermal limiter switch automatically turns off
•
the motor in the unlikely event of an overheated
situation (electric dryers only). A service techni-
cian must replace the thermal limiter switch after
correcting the fault.
Failure to comply with these warnings could
•
result in serious personal injuries.
Important Safety Instructions, con’t