Exmark Lazer ZHP - Manual (Page 11)

- 6 -
1.6 SAFETY SIGNS
1.6.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety
signs and instructional labels.
1.6.2 Safety signs must be replaced if they are missing or illegible.
1.6.3 When new components are installed, be sure that current safety signs are
affixed to the replaced components.
1.6.4 New safety signs may be obtained from your authorized Exmark equipment
dealer or distributor or from Exmark Mfg. Co. Inc.
1.6.5 Safety signs may be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.6.6 Familiarize yourself with the following safety signs and instruction labels. They
are critical to the safe operation of your Exmark commercial mower.
Serial Nos. 251,999 and Lower
PART NO. 513747
LOCATION: Top Center of Console Under Front of Seat
PART NO. 323540
LOCATION: Left Front Corner Top of
Mower Deck
PART NO. 403005
LOCATION: Left and Right Corners
of Mower Deck
PART NO. 303508
LOCATION: Front Right Corner
Top of Mower Deck
Serial Nos. 251,999 and Lower
PART NO. 603845
LOCATION: Under Seat, on Frame
Adjacent to Right Fuel Tank
PART NO. 513742
LOCATION: On Top of Mower Deck Belt
Shields, Left and Right Sides
Serial Nos. 220,000 & Higher
PART NO. 643401
LOCATION: On Tilt Switch
Serial Nos. 220,000 thru 251,999
PART NO. 643372
LOCATION: Top LH Side of Console, Under Front of Seat