Senal MC24-ES Short Shotgun Microphone Kit with Shockmount and XLR Cable - Manual (Page 7)

7
Mounting the Microphone
A.mic.clip.is.included.for.mounting.your.microphone.on.a.mic.
stand.or.boom.pole.with.a.3/8
″ .or.5/8 ″ .stud..
An.adapter.bushing.comes.installed.in.the.mic.stand..For.
mounting.on.a.5/8
″ .stud,.remove.the.bushing.from.the.
mounting.socket.of.the.mic.clip.with.a.screwdriver.or.a.coin.
Make.sure.to.mount.the.microphone.so.that.the.mic.clip.is.
not.blocking.the.side.ports.of.the.microphone..Blocking.the.
side.ports.can.affect.the.microphone’s.performance.and.polar.
pattern.and.make.it.more.susceptible.to.picking.up.off-axis.
sound.
The High-Pass Filter
Engage.the.high-pass.filter.in.settings.where.there.is.audible.
low-end.noise.such.as.air.blowers,.fans,.or.other.ambient.
noise..With.this.setting,.frequencies.below.180.Hz.are.
attenuated.
To.select.the.high-pass.filter,.move.the.switch.to.the.
(
).icon.with.a.small.screwdriver.or.the.tip.of.a.pen.
Mounting the Microphone / High-Pass Filter
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪