EverFocus EIP220 - Manual (Page 6)

Hardware Overview
1.
Reset: loading factory default configuration by pressing the button, which is
inside this hole. Please insert the keen-edged device to the hole for 10 seconds.
2.
RS485(Pelco-P/Pelco-D): RS 485 Connector functionally reserved for PTZ
control.
3.
Power LED: Power LED will light up when power is ON.
4.
Ethernet RJ-45 port: Connect to LAN via this standard RJ-45 connector.
5.
Power 12VDC: Connect with power adaptor
6.
Video Out: Loopthrough connection to the video signal from the Video In
connector. Terminated with a coaxial/BNC connector.
7.
Alarm In/Out: Connect to Alarm In/Out device.
2 4 5
6
7
1
3