Echo GT-2000R - Manual (Page 11)

G
RASS
T
RIMMER
O
PERATOR
'
S
M
ANUAL
11
A
NYLON LINE REPLACEMENT
Tools Required: None
Parts Required: Two (2) ECHO 0.080 (2 mm) Nylon Trimmer Line
203 mm (8 in.) long
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (A) in housing until ends
meet in center of recess.
FRONT
(
LOOP
)
HANDLE
NOTE
Front handle is pre-installed. Re-positioning and tightening is all
that is required.
1. Position front handle (E) in comfortable operating position and
tighten wing nut (F). The cutting attachment should be 5cm- 7.5cm
(2 in. -3 in.) above the ground and as level as possible.
E
F