Vox StompLab IIB Modeling Bass Effect Processor Pedal - Manual (Page 7)

7
Example of a connection
Bass amp, Mixer, Recorder
Headphone. etc.
AC adapter to an AC outlet
Bass
INPUT
OUTPUT/
PHONES
DC9V
Input
StompLab
Auto Power-Off function
The StompLab has an Auto Power-Off function that automatically
turns off the power when one hour has elapsed since the most
recent user input. If the auto power-off function is activated,
power will not be restored even if a button or pedal is used. Turn
the power on again.
Even if there hasn’t been any user input, the Auto Power-Off
function will not engage if there is audio input present at the
input jack.
The Auto Power-Off function is enabled as the factory default.
Enabling the auto power-off function
While holding down the EDIT button and Program DOWN pedal,
turn the power on.
After “AP” is indicated, the program/value display will indicate
“En.”
Disabling the auto power-off function
While holding down the EDIT button and Program UP pedal,
turn the power on.
After “AP” is indicated, the program/value display will indicate
“dS.”
The setting to enable or disable the auto power-off function is
saved even when the power is turned off.
Program select mode
The Program select mode is where you can select and perform
with programs.
Settings for each effect are collectively called a “program.” The
StompLab has 120 programs. These programs include 100 programs
that are preset programs (00–99) and cannot be overwritten and
20 programs that are user programs (U0–U9, u0–u9) that can be
overwritten. The 100 preset programs are divided in 10 categories
with 10 programs each.
Selecting a program
1. Check whether you are in Program select mode.
In Program select mode, the Tuner
#
LED and

LED will light
up and the EDIT LED will turn off.