Eiki LC-XB30 - Manual (Page 45)

45
Setting
Lamp mode
This function allows you to change the brightness of the screen.
Normal . .normal brightness
Auto . . . .brightness according to the input signal
Eco . . . .lower brightness reduces the lamp power
consumption and extends the lamp life.
Power management
Time left until Lamp off
Press the SELECT button at
Power management and this
box appears. Choose one of
three settings with the Point 7
8 buttons, and go to the timer
with the Point e
ed d buttons
and set time with the Point 7
8 buttons.
Power management
For reducing power consumption as well as maintaining the lamp
life, the Power management function turns off the projection lamp
when the input signal is interrupted and no button is pressed for a
certain period.
When the input signal is interrupted and no button is pressed for
30 seconds or more, the timer display with "No signal" message
appears on the screen to start the countdown.
The following operation differs according to the selected mode.
Ready . . . . . . . .When the count-down time has elapsed, the
lamp will be turned off and the POWER
indicator slowly blinks green. When any
signal is connected or any button on the
remote control or the front panel is pressed,
the projection lamp will be turned on again.
Shutdown . . . . . .When the lamp has been fully cooled down,
the power will be turned off.
Off . . . . . . . . . . . .Power management function is off.
On start
When this function is “On,” the projector is automatically turned
on just by connecting the AC power cord to a wall outlet.
✔
Note:
Be sure to turn the projector off properly (see “Turning Off the Projector” on page 21).
If the projector is turned off in the wrong steps, the On start function does not operate
properly.
Standby mode
Press the SELECT button at this
icon to display other items.
Standby mode
This function is available when using Multi Card Director optionally
supplied, and it reduces standby energy when selecting Eco.
Eco ···· reduces standby energy.
Normal ···· consumes normal standby energy.
Setting