Grilling methods, Arranging the charcoal for indirect heat, Grilling with indirect heat – weber Performer 22 Inch Performer® Deluxe Charcoal Grill Owner's Manual User Manual

Page 9: Charcoal quantity for indirect heat

Advertising
background image

9

www.weber.com

GRILLING METHODS

Arranging the Charcoal for

Indirect Heat

1. Put on barbecue mitts or gloves.
Note: The grill, including the handles, lid damper and
bowl vents, will become hot. Make sure that you are
wearing barbecue mitts or gloves to avoid burning
your hands.
2. After the charcoal is fully lit, with long tongs,

arrange the charcoal so that they will be set on
either side of the food

(B). Position the charcoal

on the sides of the bowls opposite the handles
(C). A drip pan may be placed between the
charcoal to collect drippings.

3. Replace the cooking grate.
4. Place the lid on the grill. If your grill has a

thermometer, always position the lid so that the
thermometer is not above the charcoal where it
will be exposed to direct heat

(D).

5. Open the lid damper (E).
6. Preheat the grate for approximately 10 to 15

minutes.

7. Once the cooking grate is preheated, using a

stainless steel bristle grill brush, clean the
cooking grate

(F).

Note: Use a stainless steel bristle grill brush. Replace
brush if any loose bristles are found on cooking grate
or brush.
8. Open the lid, and place your food on the grate.
9. Place the lid on the grill. Consult recipe for

recommended cooking times.

Note: When removing the grill lid during cooking,
lift to the side, rather than straight up. Lifting straight
up may create suction, drawing ashes up onto your
food.
When finished cooking...
Close the lid damper and bowl vents to extinguish
the charcoal.

Grilling With Indirect Heat

Use the indirect method for larger cuts of meat
that require 20 minutes or more of grilling time,
or for foods so delicate that direct exposure to the
heat would dry them out or scorch them, such as:
• Roasts
• Bone-in poultry pieces
• Whole fish
• Delicate fish fillets
• Whole chickens
• Turkeys
• Ribs
Indirect heat can also be used for finishing thicker
foods or bone-in cuts that have been seared or
browned first over direct heat.

With indirect heat, the heat is on both sides of the
grill, or off to one side of the grill. The food sits
over the unlit part on the cooking grate

(A).

The radiant and conductive heat are still factors,
but they are not as intense while indirect cooking.
However, if the lid of the grill is closed, as it
should be, there is another kind of heat generated:
convection heat. Heat rises, reflects off the lid and
inside surfaces of the grill, and circulates to slowly
cook the food evenly on all sides.
Convection heat doesn’t sear the surface of the
food the way radiant and conductive heat do. It
cooks it more gently all the way to the center, like
the heat in an oven.

B

E

C

D

F

A

Charcoal Quantity for Indirect Heat

Roasts, bone-in poultry pieces, whole fish, delicate fish fillets, whole chickens or turkeys, ribs

Grill Diameter

Weber

Briquettes

Needed for

First Hour

Weber

Briquettes

Added for Each

Additional Hour

Charcoal

Briquettes

Needed for

First Hour

Charcoal

Briquettes

Added for Each

Additional Hour

18" (47 cm)

10 per side

5 per side

20 per side

7 per side

22" (57 cm)

15 per side

7 per side

25 per side

8 per side

26" (67 cm)

25 per side

8 per side

40 per side

9 per side

37" (95 cm)

45 per side

18 per side

75 per side

22 per side

Advertising