LG TurboSteam Series 27 Inch Electric Dryer User Manual and Installation Guide - Manual (Page 32)

32 OPERATION
OPERATION
WARNING
• To reduce the risk of fire, electric shock, or injury to persons, read the SAFETY INSTRUCTIONS before
operating this appliance.
Using the Dryer
1
2
3
4
5
6
Clean the Lint Filter
If the lint filter has not already been cleaned, lift out the filter and remove the
lint from the last load. This will help ensure the fastest and most efficient drying
performance. Make sure to reinstall the filter, pressing down until it clicks firmly
into place.
Load the Dryer
Load the dryer with the wet laundry from the washer. If the load is extra large,
you may need to divide it into smaller loads for proper performance and fabric
care.
Turn on the Dryer
Press the Power button to turn on the dryer. The cycle LEDs will illuminate and
a chime will sound.
Select a Cycle
Turn the cycle selector knob either direction until the LED for the desired cycle
is on. The preset temperature, dry level, and option settings for that cycle will be
shown. Default settings for the selected cycle can now be changed if desired.
Refer to the Cycle Setting and Options page for details.
NOTE
• Not all options or modifiers are available on all cycles. Refer to the Cycle
Guide page for default settings and available options. A different chime will
sound and the LED will not come on if the selection is not available.
Begin Cycle
Press the Start/Pause button to begin the cycle. The cycle can be paused at
any time either by opening the door or by pressing the Start/Pause button. If
the cycle is not restarted within 60 minutes of being paused, the dryer will shut
off and the settings will be lost.
End of Cycle
When the cycle is finished, the chime will sound. Immediately remove your
clothing from the dryer to reduce wrinkling. If Wrinkle Care is selected, the dryer
will tumble briefly every few minutes to help prevent wrinkles from setting in the
clothes.