Epson EQUITY 3865X/20 PLUS - Manual (Page 143)

Post-installation Setup
After you install or remove a math coprocessor or memory
modules, you need to run the Setup program on your Reference
diskette to automatically update the computer’s configuration
information. If you install or remove any other type of option,
such as an option card or a disk drive, you must run Setup to
update your settings. For example, if you add a hard disk drive,
you need to let the computer know the type of drive you have
installed. See Chapter 2 for instructions.
Note
If you installed additional extended memory and want to use
any of it as expanded memory, see "Using Expanded Memory
Beyond 640KB” in Chapter 4 for more information.
If you install a hard disk drive that has never received a
hardware level format (such as some non-Epson hard disk
drives), you need to format the disk. Check the manual that
came with your drive, and then, if necessary, follow the
instructions in Appendix B to format your new hard disk.
If you have added a hard disk drive and you want to load
MS-DOS or another operating system from that drive, you need
to install the operating system on it. See your MS-DOS
Installation Guide or the documentation that came with your
operating system for instructions.
If you install a memory option card, use the setup program that
came with it to configure the computer for use with the card.
See your memory card manual for instructions.
Additionally, you may need to add some commands in your
configuration files. See your MS-DOS Reference Manual and
the manual that comes with your option card for instructions.
Installing and Removing Options 6-23